Table des Matières
Publicité
Using VoicE actiV atED Dialling
NOTE:
To use voice activated dialling, the voice activated dialling feature must be enabled on your device.
See your Bluetooth device manual for instructions. With the headset on, one long press on the call control
button activates the voice activated dialling feature on the headset.
mUl tiPlE UsEs of a long PrEss on tHE
call control BUtton
stAte oF the
heAdset FUnction
Bluetooth device
Turn on power
Power off
Re-link to
Power on
Bluetooth device
Link dropped
Power on
Reject call
Incoming call
Power on
Transfer a call between
Headset and Bluetooth device
On a call
Power on
Voice activated dialing
statUs inDicators
heAdset stAtUs
Powering on
Power on
Powering off
Power off
Charging battery
Battery fully charged
Discovery state
Missed call
Ringing
On Line Indicator (OLI)
Low battery
resUlt
Turns the power on
Re-links the device
Disconnects the call or sends the call
Linked
to voice mail depending on your device
Transfers the call from
Linked
one device to another
Linked
Activates the voice recognition feature
No call
heAdset stAtUs indicAtor
Blue light appears and flashes every 6 seconds
Blue light flashes every 6 seconds
Red light appears and goes off
Indicator is not lit
Red light is on
Red light is off
Indicator flashes blue and red for 30 seconds
Infrequent flashing blue/red
Press any button to cancel
Rapid flashing blue/red
Blue flash every 10 seconds
Flashes red
troUBlEsHooting
mY HEaDsEt DoEs not Work WitH mY
PHonE.
PossiBle cAUse
Headset was not in discovery mode when
mobile phone menu selections were made.
Incorrect menu selections were
made on your cellular phone.
i DiD not EntEr mY Pass kEY.
PossiBle cAUse
Your phone did not locate the headset.
Incorrect menu selections were
made on your cellular phone.
callErs cannot HEar mE.
PossiBle cAUse
Mute is turned on.
i cannot HEar callEr/Dialling tonE.
PossiBle cAUse
The headset is not turned on.
Your headset is out of range.
Your headset battery is flat.
The listening volume is too low.
solUtion
See page 5 "Bluetooth Pairing".
See page 5 "Bluetooth Pairing".
solUtion
Repeat the Pairing process on page 5.
Repeat the Pairing process on page 5.
solUtion
Press both sides of the
volume/mute button simultaneously.
solUtion
Press the call control button for 2 seconds until you hear
a beep or see the headset status indicator glow blue.
Move the headset closer
to the phone or Bluetooth device.
Charge your battery using the AC
power adapter supplied.
Press the top part of the volume/mute button
to increase the sound heard in the headset.
Publicité
Table des Matières
