Gas Connection - De Dietrich DTI1102VDE Guide D'installation Et D'utilisation

2 2 / / INSTALLING YOUR APPLIANCE
EN

GAS CONNECTION

•
• Preliminary remarks
If your hob is installed above an oven or if there is a risk of the gas supply line overheating due
to the proximity of other heating elements, a rigid pipe should be used for the gas supply.
If a flexible hose or tube is used (as is the case with bottled butane), it must not come into
contact with any moving parts or be positioned where it might become snagged.
The hob must be connected to the gas supply
in accordance with the regulations in the
country of installation.
Gas distributed by pipe, natural
•
gas, propane-air gas or butane-
air gas
For your safety, you must choose from the
three following connection options:
— Use rigid copper pipe
mechanical connectors (G1/2 gas standard
mark). Connect directly to the elbow joint
fitted on the appliance.
— Use a flexible metal corrugated hose
(stainless steel) with screw-on mechanical
connectors
(compliant
NF D 36-121) with an unlimited guarantee (Fig. A).
— Use a reinforced rubber hose with screw-
on mechanical connectors (compliant with
standard NF D 36-103) with a 10-year
guarantee (Fig. B).
Note
When connecting your hob's gas
supply, if you have to change the
direction of the elbow fitted on the
appliance:
① ① Change the gasket.
② ② Screw on the elbow's nut, careful not
to exceed a torque of 17 N.m.
with screw-on
with standard
40
Q @
Q @
Fig. A
Fig. B