Charger And Batteries - Virax Eurostem III Manuel D'utilisation

WARNING: Always keep fingers and hands away from moving parts. Failure to do so may result in serious personal injury.
4.1 Precautions when using the machine
• Never try to adjust or change the accessories
without disconnecting the battery.
• Do not use the tool when its battery is damaged.
• Do not insert fingers between the pipe and the
form or counter form when bending.
• Make sure there is enough space to rotate the
pipe before starting the bending process.
WARNING:
• Always stop the tool and disconnect the battery before any adjustment or maintenance operation.
• Apply any appropriate preventive safety measures and observe occupational health and safety rules.
▪ The manufacturer waives any liability in case of any modification of the machine by the client, as well as any damage caused by
modifications.
4.2 Battery and charger
In extreme situations, the battery may produce liquid ; avoid any contact. In the event of accidental contact, wash thoroughly with water. In
case of contact of the liquid with the eyes, call a physician immediately.
• Recharge the battery using the charger supplied with the tool or a « Metabo / CAS » type charger.
• Do not touch the charger's contacts.
• Do not expose the battery or the charger to rain or snow.
• Do not recharge your battery in a location that is exposed to direct sunlight.
• Do not recharge the battery in the presence of flammable liquids or gasses.
• Always use the charger in a temperature range between 0°C and 50°C.
• Ensure the ventilation slots are not obstructed.
• Disconnect the charger once charging finished.
• The batteries may be subject to leaks when damaged or used in bad conditions.
• To prevent short-circuits when the battery is neither on the machine nor charger, prevent contact between the battery and metallic objects
(nail, screw, etc.).
• Never use a damaged charger.
• Never use the charger if the lead or connector are damaged.
• Never use a damaged battery, change it immediately.
• Never attempt to disassemble the charger or battery.
• Never attempt to use the charger to recharge non rechargeable batteries.
• Never overload the battery.
4.3 Disposing of the batteries
• Do not disassemble the battery or remove any
component protecting the terminals.
• Li-Ion batteries must be collected, recycled and
disposed using environmentally healthy practises.

5 Charger and batteries

Before using the tool, read the instructions on its specific operation and safety conditions applicable. The tool and its accessories must be
used only for the work they were designed for. Any other use is strictly forbidden.
• Connect the charger to mains.
• Insert the battey into the charger.
• During the battery chargin.
• Remove the battery
WARNING: The batteries may be subject to leaks when damaged or used in bad conditions.
WARNING: read all instructions above before using the charger. Non application of all instructions may cause an electric shock,
fire or severe body injury.
18
Omitting to disconnect the battery before adjusting or changing
accessories may cause severe body injury.
A damaged battery increases the risk of electric shock.
Inserting fingers between moving parts can cause serious body injury.
The pipe and its extremity when rotated can cause serious body injuries.
This may cause a fire or injury. Before disposing the batteries, protect
the terminals exposed using thick insulating tape to prevent short-
circuits.
Most industrial supply distributors and supplies of office equipment
usually offer to collect and recycle batteries.
Ensure the charger is adapted to the network it will be connected to.
Ensure the battery is inserted properly into the charger.
The battery LED on the charger flashes green. During charging, the area
around the charger must be clear to prevent any risk of fire due to heating.
The battery LED on the charger is lit in green steady: the battery is fully
charged. To warranty an optimum lifetime, we recommend to charge the
battery at maximum capacity every time. The charging time is about 40min
(battery 2 Ah).
EN