Brandt BFD663ZNX Manuel D'instruction page 54

Leveling of appliance
The appliance should be leveled in
order to eliminate vibrations. We
recommend that you level the like so:
1. Roll the refrigerator into place.
2. Turn the adjustable feet (with your
fingers or a suitable spanner) until it
touches the floor. 3. Tilt back the top
backwards for about 10-15 mm and
turn the feet 1-2 turn further. This will
allow the doors to self- close and
provide a consistently closed seal.
4. Whenever you want to move the
appliance, remember to turn the feet
back up so that the appliance can roll
freely. Reinstall the appliance when
relocating.
Caution! The rollers, which are not
castors, should only be used for
forward or backward movement.
Moving the refrigerator sideways may
damage your floor and the rollers
Installing the door handles
● For convenience, information in the
part is the same as for the handle
installation guidance.
Before you use the appliance, please
install the handle.
We recommend that you install the
door handles by following phase
steps.
Required tools:
Cross screwdriver
1. Fasten the handle hold to the door
then fix two screws with a screwdriver
to make sure that the handle hole is
firmly on the door.
2. Align the handle cover and the
upper handle.
3.Forcibly combine them, making
sure they are joint tightly.
Tips:
Installing from down to up may be
easier. And the procedure installing
the lower handle is the same as upper
one.
After the installation
●After you have successfully installed
the appliance, you should clean it
thoroughly before using it. Cleaning
details can be found in the "Clean it
and care" chapter.
7