Brandt BFD663ZNX Manuel D'instruction page 65

Although this appliance automatically
defrosts, a layer of frost may occur on
the freezer compartment's interior
walls if the freezer door is opened
frequently or kept open too long. If
the frost is too thick, choose a time
when food stocks are low and
proceed as follows:
1.Remove existing
accessories baskets,
appliance from the mains power and
leave the doors open. Ventilate the
room thoroughly to accelerate the
thawing process.
2. When defrosting is completed,
clean your freezer as described
above. Caution! Don't use sharp
objects to remove frost from the
freezer compartment. Only after the
interior is completely dry should the
appliance be switched back on and
plugged back into the mains socket.
Door seals cleaning
Take care to keep door seals clean.
food and
unplug the
Sticky food and drinks can cause seals
to stick to the cabinet and tear when
you open the door. Wash seal with a
mild detergent and warm water.
Rinse and dry it thoroughly after
cleaning. Caution! Only after the door
seals are completely dry should the
appliance be powered on.
Replacing the LED light:
Warning: The LED light must not be
replaced by the user! If the LED light
is damaged, contact the customer
helpline for assistance. To replace the
LED light, the below steps can be
followed:
1. Unplug your appliance.
2. Remove light cover by pushing up
and out.
3. Hold the LED cover with one hand
and pull it with the other hand while
pressing the connector latch.
4. Replace LED light and snap it
correctly in place.
18