Makita HM1801 Manuel D'instruction page 6

1
006204
Lubrication
1
008494
1
008495
This tool requires no hourly or daily lubrication because
it has a grease-packed lubrication system. It should be
relubricated after every 6 months of operation. Send the
complete tool to Makita Authorized or Factory Service
Center for this lubrication
circumstances require that you should lubricate it by
yourself, proceed as follows.
First, switch off and unplug the tool.
Remove the cap using a lock nut wrench 20 or hex
wrench 8, then replenish with fresh grease (60 g). Use
only Makita genuine
accessory). Filling with more than the specified amount
of grease (approx. 60 g) can cause faulty hammering
action or tool failure. Fill only with the specified amount
of grease.
1. Brush holder
2
cap
2. Screwdriver
1. Cap
2
2. Lock nut wrench
20
1. Cap
2
2. Hex wrench 8
service. However,
hammer grease (optional
1
006206
Reinstall the cap and secure with the wrench.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized or Factory Service
Centers, always using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Bull point
•
Cold chisel
•
Scaling chisel
•
Clay spade
•
Rammer
•
Safety goggles
•
Hammer grease
•
Hex wrench
•
Lock nut wrench
•
if
6
1. Hammer grease
or attachments
persons. Only use
are
accessory or