Metabo HPT NV 83A2 Manuel D'instructions Et De Sécurité page 21

4 Lubricate the feeding surfaces of the nose and
the nail guide after cleaning.
This promotes smooth operation and prevents
rust.
CAUTION
● Check that the main nail stopper and sub nail
stopper slide smoothly by pushing them with
fi nger.
If not smooth, nails can be driven at an irregular
angle and hurt someone.
4. Inspecting the magazine
1 DISCONNECT AIR HOSE.
2 Clean the magazine. Remove dust or wooden tips
which may have accumulated in the magazine.
5. Storing
○ When not in use for an extended period, apply a
thin coat of the lubricant to the steel parts to avoid
rust.
○ Do not store the Nailer in a cold weather
environment.
Keep the Nailer in a warm area.
○ When not in use, the Nailer should be stored in a
warm and dry place.
Keep out of reach children.
6. WARNING LABEL
Do not use the Nailer with missing or damaged
WARNING LABEL.
A new WARNING LABEL is available from a
metabo HPT authorized service center.
7. Maintenance chart (See page 22)
8. Operator troubleshooting (See page 22)
CAUTION
● In the operation and maintenance of power tools,
the safety regulations and standards prescribed
in each country must be observed.
SERVICE AND REPAIRS
● Only
● Use only parts supplied or recommended by
All quality Nailers will eventually require servicing or
replacement of parts because of wear from normal use.
NOTE:
Specifi cations are subject to change without any
obligation on the part of metabo HPT.
Warning
Label
WARNING
service personnel
metabo HPT, distributor or employer shall
repair the Nailer.
metabo HPT for repair.
English
trained by
21