Menu - Auxiliary Heating - Helios KWL-BEC Notice D'utilisation

Operating instructions
EN
Dynamic display
Comfort controller KWL-BEC
MENU – Auxiliary heating:
This menu item is only show if an extension module KWL-EM has been connected and
recognised.
Active temperature profile
Displays which temperature profile is currently active.
(Display range 10 to 45 °C)
Dynamic display Setting temperature profile
"Fixed value" active
The following temperature profiles can be selected:
– Standard 1 = Pre-defined temperature profile
– Standard 2 = Pre-defined temperature profile
– Fixed value = Target temperature
– Individual 1 = Individual custom temperature profile
– Individual 2 = Individual custom temperature profile
Temperature profile Duct temperature "Fixed value"
The target temperature can be set from min. 10 °C to max. 40 °C via the rotary enco-
der. When extending the KWL unit with one or more humidity/temperature sensors, the
minimum (5 °C - 15 °C) and maximum (30 °C - 55 °C) duct temperatures must be set.
If only one duct sensor is installed for an auxiliary heater, the target temperature is the
selected supply air temperature. When using one or more humidity/temperature sensors,
the desired room temperature is the selected target temperature.
Edit individual temperature profile .
Different room temperatures can be set for each weekday depending on time using the
two „individual temperature profiles".
Duct temperature Min-Temp ./Max-Temp .
Before setting the individual temperatures, the minimum (5 °C - 15 °C) and maximum
(30 °C - 55 °C) duct temperatures must be determined.
10