Helios KWL-BEC Notice D'utilisation page 37

Operating instructions
+
NOTE
Comfort controller KWL-BEC
The following settings are required when the KWL unit is integrated in a computer network or directly connected to
a computer . The settings are without function for network-independent operation .
DHCP:
IP address:
Gateway:
Subnet mask:
Data synchronisation
with easyControls Portal:
Automatic firmware
updates:
System booting:
Options: Automatic IP address assignment via DHCP
"Yes" (Image left) or "No"
Display depends on DHCP settings (see above)
"Off" Enter the desired IP address
"On" Displays the assigned IP address (Image left)
Display depends on DHCP settings
"Off" Enter the desired gateway
"On" Displays the assigned gateways (Image left)
Display depends on DHCP settings:
"Off" Enter the desired Subnet mask 255.---.---.---
"On" Displays the assigned Subnet mask (Image left)
Action: When checkbox "Yes" is activated, all operation-critical parameters and
measured values are sent to the Helios portal server. You can access your KWL
ventilation unit and change settings via the Helios web portal www .easycontrols .net
when you are on the go. Further evaluations are also possible, such as temperature
profiles.
Action: When checkbox "Yes" is activated, the system will check online for new
firmware on a daily basis. If new firmware is found, it will be automatically updated.
The charging process begins between 23:00 and 05:00 hrs.
Recommendation! Enable automatic firmware updates!
Once the initial start-up is complete, the controller KWL-BEC or the system will
reboot .
5
EN