Adding Liveliness To The Sound (Dynamic Emphasis); Applying Effects To The Sound; Adding Reverberation To The Sound (Reverb); Adding Richness To The Sound (Chorus) - Roland HP109-PE Mode D'emploi

HP109-PE – Chapter 2. Performance
Adding Liveliness to the
Sound (Dynamic Emphasis)
You can add liveliness to the sound to give it superb clarity
and distinctness.
1
You can save this setting in the HP109-PE's memory
using the Memory Backup function (p. 32).
1. Press the [Dynamic Emphasis] button, getting its
indicator to light.
The Dynamic Emphasis function is switched on, enliven-
ing the sound.
2. To cancel the Dynamic Emphasis function, press
the [Dynamic Emphasis] button once more so its
illumination is turned off.
Changing the Dynamic Emphasis Settings
3. Hold down the [Dynamic Emphasis] button, and
press the [-] or [+] button.
Indicator
1 Creates a sound with boosted bass and treble.
Produces a sound with chords in the low reg-
2
isters that are clear and distinct.
3 Creates a sound with boosted bass.
18
3
Description
Applying Effects to the
Sound
I Adding reverberation to the sound (Reverb)
By applying the reverb effect you can produce a pleasant
reverberation, making it sound as though you were per-
forming in a concert hall.
1. Press the [Reverb] button.
The button's indicator will light, and a reverb effect will be
applied to the sound.
To cancel the reverb effect, press the [Reverb] button, get-
ting its indicator to go dark.
You can save the reverb on/off setting as well as the set-
ting for the amount of reverb applied in the HP109-PE's
memory using the Memory Backup function (p. 32).
I Adding richness to the sound (Chorus)
By adding the chorus effect, you can give the sound
greater dimension, with more fatness and breadth.
1. Press the [Chorus] button.
The button's indicator will light, and a chorus effect will be
applied to the sound.
To cancel the chorus effect, press the [Chorus] button, get-
ting its indicator to go dark.
You can save separate chorus effect on/off settings to
each tone individually. The original settings are restored
when the power is turned off.
I Changing the amount of effect applied
The amount (depth) of the reverb and chorus effects can be
set to any of ten levels.
With the factory settings, the reverb and chorus are set to
"5."
Changing the depth of the reverb effect
1. Hold down the [Reverb] button and press the [-] or
[+] button.
The currently specified value will be displayed. Higher
values will produce a deeper effect.
You cannot save separate reverb settings to each tone
NOTE
individually.
Changing the depth of the chorus effect
1. Hold down the [Chorus] button and press the [-] or
[+] button.
The currently specified value will be displayed. Higher
values will produce a deeper effect.