Remote Control; Timer Programming - Zibro P 122 Manuel D'utilisation

a
b
c c
d
e g
f
4
76
man_P1xx_1.indd 76
G
NOTE!
The compressor has been set so that it starts functioning three minutes
after the (re)start of the air conditioner.
The cooling will switch off when the room temperature is lower than
the set one. Air circulation will however continue to work on the set
level. When the room temperature rises above the selected value, the
cooling will work again.

REMOTE CONTROL

a. LCD Screen
b. Power on/off button
c. Timer and thermostat setting buttons
d. Mode button (select A/C, Fan or Dehumidifier)
e. A/C Fan Speed button (High, Medium, Low)
f. Timer ON / OFF button
g. Celsius / Fahrenheit selector
The remote control works in combination with the control panel. Aim the front
end of the remote control at the red window. The maximum operating distance
from the air conditioner is approximately 5 metres. Place 2 pieces of AAA Batteries
before use.

TIMER PROGRAMMING

1 Press the button on the remote or the "Timer Setting" button on the
control panel to turn on the Timer Function.
2 Press the or buttons on the remote or the
control panel to set the desired shut-off period.
3 The unit will shut off when the set time elapses.
DEHUMIDIfACATION OPERATION
Press the button on the remote or the MODE button on the control panel to
select the dehumidifier mode. The fan will operate on medium speed.
The dehumidifier indicator light will illuminate and stay solid while the unit is
dehumidifying. When the humidity in the room is 50% or lower, the compressor
will not run, the unit will not dehumidify, and the dehumidifier light will blink.
Remember, the exhaust hose does not need to be used in dehumidifier mode.
or buttons on the
22-12-10 12:32