Zibro P 122 Manuel D'utilisation page 74

4
74
man_P1xx_1.indd 74
connector 9 to the window air outlet K.
7 Attach the hose connector K to air outlet 7 at the back of the unit. Lead the
hose connector K outside and close the gap with the foam components
supplied. These may have to be cut to size.
8 Keep windows and outside doors closed as much as possible in order to
prevent the inflow of exterior air. The air that is intended to enter the room
(specifically during the use of a single hose) in order to allow the airconditioner
to function correctly must always be as cool as possible. Leading this air
through a passage or adjacent room increases the comfort level.
G
IMPORTANT
The flexible air exhaust hose can be stretched to a length of
approximately 1500 mm. The length of these hose(s) was calculated
on the basis of the capacity of the device. The use of other hoses or
extensions may cause faults in the device. The air must be able to flow
unhindered. If this is not possible this may lead to overheating or water
condensation in the air exhaust hose. This is why you must ensure that
there are no kinks or sharp corners in the air hose(s). To obtain an
optimum result, the air hoses must be kept shorter than 1 metre while
the airconditioner is in use.
C
OPERATION
1 Insert the plug into the wall outlet.
2 Press the -button to switch on the air conditioner.
3 With -button you can change the operating mode of the unit.
By pressing the
Cooling, the green light lits.
Dehumidifying, the orange light lits.
Air circulation, the yellow light lits.
COOLING
When the unit is in the cooling mode, the following functions apply:
• The fan speed can be adjusted by pressing the
Maximum setting.
Medium setting.
Lowest setting.
-button the following modes appear:
-button
22-12-10 12:32