Braun Oral-B PRO TRIZONE 6000 Mode D'emploi page 14

h Charging unit (basic charger and brush head
compartment with protective cover)
i SmartGuide
j SmartGuide holder
k Wall mount
l Adhesive ring
m Travel case (depending on model)
n Travel charger pouch (depending on model)
Specification
For voltage specifications refer to the bottom of the
charging unit.
Connecting and charging
Your toothbrush has a waterproof handle, is
electrically safe and designed for use in the
bathroom.
• Plug the charger (h) into an electrical outlet and
place the toothbrush handle (e) on the charging
unit.
• The flashing blue lights indicate that the tooth-
brush is charging (picture 1, page 5); once it is
fully charged, the lights turn off. A full charge can
take up to 24 hours and enables up to ten days of
regular brushing (twice a day, 2 minutes).
Note: After deep discharge, the blue lights might
not flash immediately; it can take up to 10–15
minutes.
• If the rechargeable battery is low a blue light is
flashing on the charge level display (g) for some
seconds when turning your toothbrush on/off. If
the rechargeable battery is empty the motor will
stop and an orange light is flashing on the charge
level display; it will need a 40-minute charge
before you can use it for a 2-minute brushing.
• For everyday use, the toothbrush handle can be
stored on the charging unit to maintain it at full
power. Overcharging is impossible.
• To maintain the maximum capacity of the
rechargeable battery, unplug the charging unit
and fully discharge the handle with regular use
at least every 6 months.
SmartGuide adjustments
The SmartGuide (i) comes with a demonstration
mode. Deactivate this mode by removing the
compartment cover in the back (picture A, page 4)
and push the «set» or «h/min» button.
A flashing «12:00» indicates that you can now adjust
the clock time.
Note: If the SmartGuide display is blank before first
use (no active demonstration mode/no batteries
inserted) the batteries will need to be replaced/
inserted before continuing. Batteries are supplied.
Clock Time
Press and hold the «set» button until «12h» is
displayed. By briefly pressing the «h/min» button,
you can toggle between «12h» or «24h» daytime
format. Push «set» to confirm your choice. Then the
hour digit starts flashing. Press the «h/min» button
until the right hour appears and confirm with «set».
Proceed same way to set both minute digits
(picture B, page 4).
SmartGuide Icons
(depending on model)
Displayed Meaning
Icon
«Daily Clean» mode
«Deep Clean» mode
«Sensitive» mode
«Whitening» mode
«Gum Care» mode
«Tongue Cleaning» mode
Too much pressure is applied.
Reduce the brushing force.
«Quadrant circle»
Move to the next quadrant of your
mouth when the relevant segment
flashes.
You reached the dentist recom-
mended 2-minute brushing time
(3-minute brushing time within the
Deep Clean mode).
After use your brushing time will be
rewarded with stars.
SmartGuide batteries are low.
Change batteries of the SmartGuide.
15