Safety Clearances; Test Symbols; Appliance Description; Operation - Stiebel Eltron Ultronic S Mode D'emploi

oPerATIoN

Appliance description

WARNING Burns
Never operate this appliance
- in rooms where the appliance is at risk from fire or
explosion as a result of chemicals, dust, gases or
vapours.
- in the direct proximity of pipes or receptacles that
carry or contain flammable or explosive materials.
- if work such as laying tiles, sanding or sealing is
being carried out in the installation room.
- if naphtha, sprays, floor polish or similar products
are handled. Ensure the room is adequately venti-
lated before using the appliance.
CAUTION Burns
- Never lean any objects against the appliance or
insert them between the appliance and the fixing
wall.
- Never place any flammable, combustible or insulat-
ing objects or materials, such as laundry, blankets,
magazines, containers with floor polish or naphtha,
spray cans or similar on the appliance or in direct
proximity to it.
CAUTION Burns
Parts of the appliance can get very hot and may cause
burns. Particular caution is advised when children or
vulnerable persons are present.
Never cover the appliance
Never cover the appliance to prevent overheating of the
appliance.
Material losses
!
If the appliance is installed in rooms where flue gas, oil or
petrol vapours occur or where work involves solvents and
chemicals, the operation of the appliance can result in
long-lasting nuisance through odours or contamination
of the appliance.
2.3

Safety clearances

Material losses
!
Maintain the required minimum clearances.
The appliance's air inlet and outlet must not be obstructed
by any objects.
The minimum clearances of the appliance can be found in chapter
"Specification / Minimum clearances and detection range".
2.4

Test symbols

See type plate on the appliance. The type plate is located at the
bottom of the appliance.
14 | Ultronic S/W
3. Appliance description
The appliance works without contact. If you hold your hands in
the IR sensor detection range, the appliance fan is automatically
enabled.
Heated air is discharged from the appliance at high speed. Any
moisture left on your hands is removed and your hands are dried.
When you move your hands away from the IR sensor detection
range, the appliance stops automatically after approx. 3 seconds.
4. Operation
f Shake your wet hands over the sink before drying to reduce f
the drying time.
f Hold your hands under the air outlet and rub them together f
in the air current.
Note
The IR sensor response area is located approx. 3-4 cm
below the air outlet. More information on the detection
range of the IR sensor can be found in chapter "Specifi-
cation / Minimum clearances and detection range".
5.

Cleaning, care and maintenance

Material losses
!
Never spray the appliance using a water hose or other
tools. This would let water penetrate the appliance.
A damp cloth is sufficient for cleaning the casing. Never use
abrasive or corrosive cleaning agents. Go over with a soft cloth
if required.
6.

Troubleshooting

Problem Cause
The appliance No power supply
does not
start.
Covering the optical proximity
sensor impairs the function of
the appliance. In this case, the
appliance stops after approx.
3 seconds to avoid constant op-
eration.
If you cannot remedy the fault, notify your qualified contractor.
To facilitate and speed up your request, provide the number from
the type plate (000000-0000-000000).
remedy
Check whether a fuse or RCD
has blown or tripped in your
fuse box.
Check whether the sensor sur-
face is clear. Once you have re-
moved any objects, the appli-
ance will work correctly again.
www.stiebel-eltron.com