Safety Clearances; Ce Designation; Test Symbols; Appliance Description - Stiebel Eltron Ultronic S Utilisation Et Installation

OPeRatIOn

appliance description

2.3

Safety clearances

Damage to the appliance and environment
!
Maintain the required minimum clearances.
The appliance's air inlet and outlet must not be obstruct-
ed by any objects.
The minimum clearances of the appliance can be found in chapter
"Specification / Minimum clearances and detection range".
2.4

ce designation

The CE designation shows that the appliance meets all essential
European requirements:
- Low Voltage Directive
- Electromagnetic Compatibility Directive
The maximum permissible mains impedance is indicated in chap-
ter "Specification".
2.5

test symbols

See type plate.
3. Appliance description
The appliance works without contact. If you hold your hands in
the IR sensor detection range, the appliance fan is automatically
enabled.
Heated air is discharged from the appliance at high speed. Any
moisture left on your hands is removed and your hands are dried.
When you move your hands away from the IR sensor detection
range, the appliance stops automatically after approx. 3 seconds.
14 | Ultronic S/W
4. operation
f Shake your wet hands over the sink before drying to reduce f
the drying time.
f Hold your hands under the air outlet and rub them together f
in the air current.
Note
The IR sensor response area is located approx. 3-4 cm
below the air outlet. More information on the detection
range of the IR sensor can be found in chapter "Specifica-
tion / Minimum clearances and detection range".
5.

cleaning, care and maintenance

Damage to the appliance and environment
!
Never spray the appliance using a water hose or other
tools. This would let water penetrate the appliance.
A damp cloth is sufficient for cleaning the casing. Never use abra-
sive or corrosive cleaning agents. Go over with a soft cloth if re-
quired.
6.

troubleshooting

Problem cause
The appli- No power supply
ance does
not start.
Covering the optical proximity
sensor impairs the function of
the appliance. In this case, the
appliance stops after approx.
3 seconds to avoid constant op-
eration.
If you cannot remedy the fault, notify your contractor. To facilitate
and speed up your enquiry, please provide the serial number from
the type plate (000000-0000-000000).
The type plate is located at the bottom of the appliance.
Remedy
Check whether a fuse or RCD
has blown or tripped in your
fuse box.
Check whether the sensor sur-
face is clear. Once you have re-
moved any objects, the appli-
ance will work correctly again.
www.stiebel-eltron.com