Installation; Safety; General Safety Instructions; Instructions, Standards And Regulations - Stiebel Eltron Ultronic S Mode D'emploi

INSTALLATIoN

Safety

INSTALLATIoN
7. Safety
Only a qualified contractor should carry out installation, commis-
sioning, maintenance and repair of the appliance.
7.1

General safety instructions

We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
7.2

Instructions, standards and regulations

WARNING Electrocution
Carry out all electrical connection and installation work
in accordance with relevant regulations.
WARNING Electrocution
Only use a permanent connection to the power supply.
The appliance must be able to be separated from the
power supply by an isolator that disconnects all poles
with at least 3 mm contact separation.
Material losses
!
Observe the type plate. The specified voltage range must
match the mains voltage.
Note
Observe all applicable national and regional regulations
and instructions.
8.

Preparations

8.1

Installation wall

Note
Observe the information in chapter "Operation / Safety".
Always install the appliance on a vertical wall.
The back panel of the appliance must be flush with the wall to
ensure that the appliance cannot be pulled off.
f Ensure that the wall on which the appliance is mounted is f
solid and has no recesses.
www.stiebel-eltron.com
8.2

Installation in bathrooms

WARNING Electrocution
Install the appliance exclusively outside safety zone 2.
3
0 Safety zone 0
1 Safety zone 1
2 Safety zone 2
3 Safety zone 3
8.3

Minimum clearances

f Prior to installing the appliance, ensure the minimum per- f
missible clearances to adjacent objects are observed.
f Ensure that the ambient air can enter the inlet on the bottom f
of the appliance without obstruction.
f Ensure that the air can escape from the appliance without f
obstruction.
1
0
2
Ultronic S/W | 15