Assembling The Casing Cover; Handover; Specification; Wiring Diagram - Stiebel Eltron Ultronic S Mode D'emploi

INSTALLATIoN

Handover

9.3.2 Connecting the appliance
1 Power cable
2 Cable entry
f Pull the power cable through the cable entry in the back f
panel of the appliance.
f Position the appliance with the keyhole eyelets on the fixing f
screws.
f Secure the appliance to the wall with the 2 upper fixing f
screws and then tighten the 2 lower screws.
f Connect the appliance to the power supply according to f
the wiring diagram (see chapter "Specification / Wiring
diagram").
9.4

Assembling the casing cover

2.
1.
f Push the casing cover on to the appliance from the front. f
f Place the top of the casing cover on the back panel of the f
appliance so that the fixing eyes lock under the hooks (see
chapter "Dismantling the casing cover").
f Press the bottom of the casing cover on to the appliance so f
that it clicks into place.
www.stiebel-eltron.com
1
2
f Check that the casing cover is fitted correctly on the f
appliance.
f Tighten the 2 internal torx screws with a torx screwdriver 25, f
turning it anti-clockwise as far as it will go.
10. Handover
Explain the functions of the appliance to the user. Draw special
attention to the safety instructions. Hand over these operating and
installation instructions to the user.

11. Specification

11.1 Wiring diagram

3.
Ultronic S/W | 17