Energy Efficiency Overview; Installation And Wiring; Pump Location - Hayward Super Pump VS Manuel Du Propriétaire

3. Energy Efficiency Overview

The energy consumed by a pool pump is measured in terms of Watts (W) or Kilowatts (kW). The Super Pump VS Variable
Speed Pump displays power consumption in Watts. Given this information, you can determine the cost of operating the
pump:
Power consumption of pump X Cost of electricity = Cost of Pump Operation per Hour
Example: Super Pump VS Variable Speed Pump operating at 300 W. Cost of electricity = $0.10 per kWh
Convert Watts to Kilowatts: 300 W = 0.3 kW
0.3 kW X $0.10/kWh = $0.03 per hour
Note the power consumption is greatly affected by the speed of the pump. Lowering the speed of the pump can
drastically reduce the power that is consumed. Below are some of the major benefits of running the pump at lower
speeds.
Benefits of running at low speeds

Save electricity and money

Improved filtration – the filter can often remove smaller particles when the water moves slower

Quiet operation

Reduced Total Dynamic Head – less stress on equipment (e.g. filter) which can lengthen equipment life
When determining the speed(s) to operate your pump, you must also take into account the minimum requirements for
proper sanitation and equipment/water feature functionality.
It is recommended you filter ("turnover") all the water in the pool at least once every 24 hours. Check with local
requirements for the minimum turnover rate. Running the pump at a lower speed may require running the pump for a
longer period of time in order to meet the turnover requirements for proper sanitation.
Equipment such as heaters, skimmers, and chlorinators require minimum flows to operate correctly. Refer to individual
equipment manuals for specific flow requirements.
After setting the pump speed(s), it is recommended you check that all other equipment/water features are functioning as
intended. For example, when running at a low speed for daily filtration, verify water is adequately flowing over the
skimmer weirs. Operate the pump at higher speeds for the shorter periods of time needed to operate a heater, water
feature, etc.

4. Installation and Wiring

WARNING
Note: For FCC part 15 compliance, use flexible metallic conduit or a shielded power supply cable when installing this
device.

4.1. Pump Location

Page 8 of 32
– This product should be installed and serviced only by a qualified professional.
Locate pump as close to pool as practical and run suction lines as direct as possible to
reduce friction loss. Suction lines should have continuous slope upward from lowest
point in line. Joints must be tight (but not over-tightened). Suction line diameter must
equal or be larger than the discharge line diameter.
Though the pump is designed for outdoor use, it is advised to place pump and filter in the
shade to shield them from continuous direct heat. Select a well-drained area that will not
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Super Pump VS Variable Speed Pump IS26115VSP Rev-A