Remote Control Wiring/Operation; Digital Control Interface Orientation - Hayward Super Pump VS Manuel Du Propriétaire

4.10. Remote Control Wiring/Operation

Super Pump VS can be controlled in a wide variety of ways as described below:
1. Super Pump VS can operate by itself in Stand-Alone Mode using its built-in programmable timers.
2. Super Pump VS can also be controlled from third party controls (i.e. another manufacturer's control) and
Hayward controls that are not software compatible using relay contacts. See section 5.3 for more information
regarding connecting Super Pump VS and third party/non-software compatible Hayward controls.

4.11. Digital Control Interface Orientation

The Digital Control Interface can be rotated to any of four desired positions after installation by loosening the two
screws securing the user interface to the motor drive, lifting the user interface and rotating it to the desired position,
and tightening the two screws in the new position. (Figure 4.11-1)
Page 11 of 32
Figure 4.11-1
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
Super Pump VS Variable Speed Pump IS26115VSP Rev-A