Optional Blower Installation - Napoleon Ascent B46NTR Manuel D'installation Et D'opération

WARNING
!
• Ensure the appliance is completely cool before starting installation.
• To avoid danger of suffocation, keep the packaging bag away from babies and children. Do not use in cribs,
beds, carriages, or play pens. This bag is not a toy. Knot before throwing away.
1. Remove the safety barrier by lifting it up and off the appliance.
2. Remove the door from the appliance by releasing the four latches.
note:
It may be necessary to move the control module aside during blower installation (electronic only).
3. Attach the two 1/4" connectors (black and white) from the wire harness to the thermodisc.
4. Attach the two 1/4" connectors (black and red) from the wire harness to the blower.
5. Install the clear bumpers (supplied) onto the bottom of the blower to avoid the blower rubbing against the
fl oor of the applinace.
6. Pivot the blower into the bottom of the appliance, ensuring the gasket remains in place between the blower
and outer shell while sliding the blower against the left side of the outer shell into the blower mounting tab.
Secure in place using one screw (Fig. 1 and 2).
note:
With the zip tie supplied, ensure all wires remain clear of the blower.
FIGURE 4
SCREW
LOCATION
7. Place the control module back into its original position. Ensure the transformer is plugged into the rear outlet
of the electrical box.
8. The variable speed swithc (VSS) will need to be disassembled to secure to the VSS bracket for installation.
Place the VSS through the mounting bracket using the lock washer to secure it in place. Take the variable
speed switch knob and install into position (Fig. 3).
9. To install the variable speed swtich, the mounting bracket will fi rst need to be installed. Remove the two
screws securing the piezo ignitor switch bracket in place. Install the VSS mounting bracket ito position then
reinstall the two previously removed screws (Fig. 3).
VSS
BRACKET
10. Plug the connector from the variable speed switch to the matching connection of the wire harness.
11. For installation of the thermal disc bracket, bend the tab on the bottom of the fi rebox 90 degrees. This will be
the mounting tab for the thermal disc bracket (Fig. 4).
12. Bend the thermal disc bracket 90 degrees and secure it to the fi rebox mounting tab using the two screws
supplied (Fig. 4). Ensure that the thermal disc is in contact with the fi rebox base and that the wire harness is
properly attached.
13. Plug the power cord from the blower into the electrical box.
note:
The blower is thermally activated, so when it is turned on, it will automatically start approximately 15 minutes
after lighting the appliance and will run for approximately 30 minutes after the appliance has been turned off.

11.0 optional blower installation

BLOWER
MOUNTING TAB
LOCATION
Fig. 1
PIEZO IGNITOR
BRACKET
Fig. 3
FIGURE 5
BLOWER BLOWER
THERMAL DISC THERMAL DISC
MOUNTING TAB BRACKET
EN
REAR VIEW REAR VIEW
BLOWER BLOWER
MOUNTING MOUNTING
TAB TAB
Fig. 2
FIREBOX BASE
Fig. 4
55
W415-1613 / F / 03.12.19