Whirlpool WRF954CIHB Guide De L'utilisateur page 23

Max Cool
The Max Cool feature assists with periods of high refrigerator
use, full grocery loads, or temporarily warm room temperatures.
To turn on the Max Cool feature, press the Max Cool button.
■
When the button is pressed, the icon will blink 3 times and
appear on the display screen.
To manually turn off the Max Cool feature, press the Max
■
Cool button and the display will blink 3 times and turn off.
The Max Cool feature will remain on for 24 hours unless
manually turned off. Adjusting the refrigerator temperature
will automatically turn off the Max Cool feature.
NOTE: Setting the freezer to a colder temperature may make
some foods, such as ice cream, harder.
Max Ice
The Max Ice feature assists with increasing the cooling for the
freezer compartment in order to increase ice production.
To turn on or off the Max Ice feature, press the Max Ice
■
button. When the button is pressed to turn the feature on,
the icon will blink 3 times and appear on the display screen.
To manually turn off the Max Ice feature, press the Max Ice
■
button and the display will blink 3 times and turn off. The Max
Ice feature will remain on for 24 hours unless manually turned
off. Adjusting the refrigerator temperature will automatically
turn off the Max Ice feature.
NOTE: Setting the freezer to a colder temperature may make
some foods, such as ice cream, harder.
Water Filter Reset
Displays the status of the water filter. To reset the filter, press
MAX ICE and MAX COOL for 3 seconds. After countdown, the
Good icon will blink 3 times and remain lit.
NOTE: The Water Filter status lights on the internal controls will
let you know when to change your water filter.
ORDER FILTER (Yellow): Order a replacement water filter.
■
REPLACE FILTER (Red): Replace the water filter. While
■
you are dispensing water, "Replace" Filter icon will flash
constantly from beginning to the end of dispensing. After
14 days without replacing the water filter, the "Replace"
Filter icon will blink 7 times and an alert tone will sound
3 times, at the end of dispensing. See the "Water Filtration
System" section.
NOTE: REPLACE FILTER will remain illuminated if a filter
reset is not done.
RESET FILTER: Touch MAX ICE and MAX COOL at the same
■
time on the Temperature Control display for 3 seconds to
reset water filter. The display will do a 3-second countdown
and then flash the icon and play a tone.
Energy Saver Mode
A selectable feature that turns off the heaters around the
refrigerator doors and dispenser. When this feature is enabled,
condensation may form on the front of the refrigerator cabinet,
gasket, or on top of the freezer drawer. Savings may vary based
on the relative humidity of environment.
To turn the mullion heater off, press and hold the Energy
■
Saver button for 3 seconds. The Energy Saver icon will blink
3 times and then remain lit as shown.
IMPORTANT: When Energy Saver is enabled, and the LED is on,
the dispenser heater and vertical mullion heater will be turned off.
Press and hold ENERGY SAVER for 3 seconds again to turn
■
the heaters back on.
Freeze Shield Mode
This feature minimizes moisture migration from frozen food.
This, in turn, reduces the freezer burn occurrence.
To turn on the Freeze Shield mode, toggle to the coldest freezer
temperature set point. Freeze Shield is activated at -6°F (-14°C).
To turn off the Freeze Shield mode, toggle from the coldest
freezer set point to any other temperature.
Sound On/Off
The Sound button allows the customer to turn the sound on
and off.
To turn on the Sound feature, press the Sound button. When
■
the button is pressed, the sound icon will blink 3 times and
appear on the display screen.
To manually turn off the Sound feature, press the Sound
■
button and the display will blink 3 times and turn off.
Power Outage
The Power Outage indicator lets you know if the power supply
to the refrigerator has been off and the freezer temperature has
risen.
The control panel display will read "Power Outage" and an alert
tone will sound 3 times. Touch any button to stop the tone, and
touch any button again to turn off Power Outage icon.
Once the power outage has been confirmed, "Power Outage"
icon will disappear and the display will return to the Home screen.
23