Publicité
Les langues disponibles
Les langues disponibles
1.0 GENERAL COMMENTS
1.1 WARNINGS
The aim of this pump manual is to provide you with all the necessary information for a proper
installation and maintenance in order to give you optimum results whilst in operation.
For this reason it is really important reading with attention the instructions given below since
they furnish all the indications necessary for the sureness of the installation, use and mainte-
nance.
_ This manual has to be preserved with care to be consulted in whatever occasion.
_ At the moment of the receipt you have to check the integrity of the pump and of all its com-
ponents, in case of anomalies consult skilled staff before making interventions.
_ Before the installation of the pump check that all the data on the pump's label correspond to
those of the electrical plant.
_ Do not operate with bare/naked hands or feet
_ Do not leave the equipment exposed to the action of the atmospheric agents.
_ The equipment has to be operated from skilled person.
_ In case of improper functioning of the pump switch off and contact our technical assistance
for any necessary repairs.
_ For a correct functioning it is necessary to use original spare parts and original accessories.
The producer declines whatever responsibility in reference with break down due to tampering
or the use of not original spare parts and accessories.
_ The electrical plant has to be in conformity with the rules of the country where it is realised.
_ The room temperature of utilisation can't over take 45° C.
1.2 DESIGN STANDARD
Our pumps are built according to the actual general directives endowed with CE mark in
conformity with the following European directives:
_ N° 89/336/CEE regarding "electromagnetic compatibility"
_ N° 73/23/CEE regarding "low voltages", as also the subsequent modification N°93/68/CEE
_ and according to the procedures preview from our quality manual that follows the ISO
14001:1996 and
ISO 9001:2000 directives.
Granted this we think that in order to obtain an high trustworthiness and a lasting functioning
of the pump it is necessary to follow with attention our manual particularly in reference with
the maintenance.
The producer declines all responsibility in reference with whatever intervention on the equip-
ment from not skilled personnel.
2.0 TECHNICAL CHARACTERISTICS
2.1 GENERAL RULES
Install the pump :
_ On the wall so that the pump head stays always in vertical position +/-15°.
_ far from an hot source in dry places at maximum temperature of 45°C and minimum 0°C.
Page 13
Publicité
