Publicité
Les langues disponibles
Les langues disponibles
Reassembly
1. Press the frame onto the rest of the mask, ensuring it clicks into place
at the top and at both bottom corners.
2. Attach the top headgear straps to the frame by looping through each
of the upper headgear hooks. Ensure that the ResMed logo on the
headgear is facing outward and right side up.
3. If the quick release clip has been removed from the frame, reattach it
by threading it onto the lower right headgear hook.
4. If the quick release has been disassembled, reclip the parts together
as shown in the reassembly illustrations.
5. If the quick release has been removed from the headgear, thread the
lower right headgear strap through the slot on the quick release. Fold
the tab over to reattach.
6. Attach the elbow to the air tubing. Attach the elbow and air tubing to
the mask by pressing the side buttons and pushing the elbow into the
mask. Pull on the elbow to check that it sits securely in the mask.
Cleaning your mask in your home
Your mask and headgear should only be handwashed by gently rubbing in
warm (approximately 86°F/30°C) water using mild soap. All components
should be rinsed well with drinking quality water and allowed to air dry
out of direct sunlight.
WARNING
Always follow cleaning instructions and use mild soap. Some
cleaning products may damage the mask, its parts and their function,
or leave harmful residual vapors that could be inhaled if not rinsed
thoroughly.
CAUTION
If any visible deterioration of a system component is apparent
(cracking, discoloration, tears etc.), the component should be
discarded and replaced.
4
Publicité
