Table des Matières
Publicité
Net Address The Net setting on the NEXT NXT-1 determines the first number in the IP address.
Subnet Address The Subnet address in Art-Net™ adds 16 to the Universe address for each Subnet integer. To
Universe To configure the Art-Net™ Universe for the NEXT NXT-1, follow the instructions below:
Start Channel To set the DMX starting address in Art-Net™ modes, do the following:
Art-Net™ and DMX Configuration
Kling-Net and DMX Configuration
NEXT NXT-1 User Manual Rev. 7
To configure the Art-Net™ Net address for the NEXT NXT-1, follow the instructions below:
1.
Press <MENU/ESC> repeatedly to reach the main level of the display menu.
2.
Use <UP> or <DOWN> to select ArtNet Setup.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Net.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> to set the Net address to 0 (for an IP address beginning with 2) or 1
(for an IP address beginning with 10).
7.
Press <ENTER>.
Net addresses higher than 1 have no function and are reserved for future use.
calculate the actual Universe setting, take the Subnet value, multiply it by 16, and add the
Universe value.
For example, to set Universe 200, set the Subnet address to 12 (12x16=192) and the Universe
to 8.
To configure the Art-Net™ Subnet address for the NEXT NXT-1, do the following:
1.
Press <MENU/ESC> repeatedly to reach the main level of the display menu.
2.
Use <UP> or <DOWN> to select ArtNet Setup.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Subnet.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> to increase or decrease the Subnet address, from 0–15.
1.
Press <MENU/ESC> repeatedly to reach the main level of the display menu.
2.
Use <UP> or <DOWN> to select ArtNet Setup.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Universe.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN>. to set the Universe, from 0–15.
7.
Press <ENTER>.
1.
Press <MENU/ESC> repeatedly to reach the main level of the display menu.
2.
Use <UP> or <DOWN> to select ArtNet Setup.
3.
Press <ENTER>.
4.
Use <UP> or <DOWN> to select Start Channel.
5.
Press <ENTER>.
6.
Use <UP> or <DOWN> to increase or decrease the starting address, from 1–512.
In ArtNet+DMX mode, the NEXT NXT-1 will respond to a DMX controller and an Art-Net™
console simultaneously. For this to work correctly, the following must be observed:
·
DMX values from the DMX controller must not interfere with the Art-Net™ signal.
For example: if Art-Net™ is controlling the LED output, no DMX channel that affects the
LEDs should be set to any value other than zero.
·
For compatibility with pixel mapping software that does not account for pan, tilt, or master
dimmer functions, the DMX Personality must be set to either <106CH> mode or < 81CH>
mode. (See DMX Personality.)
In KlingNet+DMX mode, the NEXT NXT-1 will respond to a DMX controller and a Kling-Net
console simultaneously. Only the DMX starting address must be configured for this mode. All
settings and functions other than pan and tilt will be controlled by the Kling-Net console.
Operation
-11-
Publicité
Table des Matières
