ATIKA BWS 700 N Notice Originale page 17

Possible faults
Before each fault elimination:
− Switch off device
−
Wait unitl the saw comes to a stop.
− Pull out power plug
After each fault clearance, put into operation and recheck all security installations.
Fault
Machine fails to start after switching on • Power failure
Jigging does not work
Machine stops while cutting
Burned spots at the cut areas
Saw vibrates
Recuperating mechanism of the jigging
device does not work
Decelaration too slow (time to dead
stop >10 sec.)
Technical data
Type
Year of construction
Motor rating P
1
Mains voltage
Mains frequency
No-load speed
Protection class
Mains fuse
Carbide tipped saw blade ∅
Saw blade location hole ∅
Number of teeth
Thickness of splitting wedge
Cut width
Cutting capacity
Wood length, max.
Wood length, min.
Dimensions (length x breadth x height)
Weight (incl. accessories)
Operating mode: S6 – 20 %
Continuous intermittent operation
For 10 min.:
2 min. continuous operation
8 min. operation at no or low load
Guarantee
Please observe the enclosed terms of guarantee.
Possible cause
• Extension cable defect
• Motor or switch defect
• Safety hook is not released
• Saw blade blunt
• Feed is too great
• Saw blade blunt
• Saw blade is warped
• Saw blade not properly mounted
• Recuperating spring broken or worn out
• Brake defective
• Different causes
Remedy
• Check the fuse.
• Check cable, no longer use defect cable
• Have motor or switch checked by an approved
electrician or replaced by original spare parts
• Release the safety hook (3).
• Replace saw blade or have it sharpend
• Allow motor to cool and proceed working with less
pressure
• Replace saw blade or have it sharpend
• Replace saw blade
• Mount saw blade properly
• Replace the recuperating spring
• Switch checked by an approved electrician or
replaced by original spare part
approx. ∅ min. 30 mm to max. 240 mm
Approx. 1150 x 745 x 1085 mm
BWS 700 N
see last page
4,5 kW S6 20 %
400 V 3~
50 Hz
approx. 1490 min
–1
IP 54
16 A intert
700 mm
30 mm
42
3.2 mm
4.2 mm
approx. 1000 mm
approx. 200 mm
approx. 98 kg
17