patura P 15 Mode D'emploi page 18

Connecting the energiser
to the fence
1 Push the earth rod fully into firm ground.
2 Connect the green earth lead from the energiser's
fence earth terminal (
3 Connect the red fence lead from the energiser's
fence output terminal (
4 Make sure there is a good contact. If necessary,
carefully strip the polywire to expose steel strands
in order to provide a good connection.
Operation
Turning the energiser on
Turn the switch to .
The indicator light will illuminate green for
approximately 2 seconds indicating that the energiser
is operating and that the battery voltage level
is OK.
The energiser then produces an output pulse every 1.5
seconds and the indicator light flashes green with each
pulse.
Turning the energiser off
Turn the switch to
18
) to the earth rod.
) to the fence.
.
Indicator light
The indicator light shows the energiser and
battery status:
Indicator light Indicates
Indicator light Battery
illuminates green voltage is
for two seconds OK.
when energiser is
first switched on.
Indicator light Energiser is
flashes green operating
once every 1.5 and the
seconds energiser
output
voltage is
OK.
Indicator light Battery
flashes green voltage has
once every three dropped
seconds (only below 11.8 V.
when connec-
ted to a 12 V
external
battery)
Indicator light Battery volta-
illuminates red ge is low.
for two seconds
when energiser is
first switched on.
Action
Recharge or
replace
external
12 V battery.
Replace
internal 9 V
battery.
Recharge or
replace
external 12 V
battery.