Comelit 3451 Manuel D'utilisation page 3

Self-testing
On power-up, the device runs a diagnostic test of the connections to
check for correct communication and configuration.
The message PLEASE WAIT indicates self-testing in progress. On
completion of self-testing, the module goes back into standby.
Finding a name in the directory
√ In standby
1. Press to access the directory search function.
2. Enter the name (full name or just the first letter).
M_
ESC
Press the relevant key repeatedly to enter special characters
Special characters
,;:._-#*"1 ABCÅÄĄÆßČĆ2
GHI4
PQRS7 TUVÜ8
space 0
3. Press to start searching.
4. Scroll through the directory using
MARIO ROSSI
CODE: (00000)
SCROLL
5. Press to make the call or
OK
CANC
DEFÉĘĚ3
JKLŁ5 MNOŃÖØÓ6
WXYZ9
.
002
CALL
to exit.
Calling a user
√ In standby
1. Enter the user code (e.g.: 2).
2. Press to make the call or
CALL USER
( _ _ _ _ _ ) _ _ 2
CALL
or:
1. Scroll through the directory using
2. Press to make the call or
MARIO ROSSI
CODE: (00000)
SCROLL
√ For 1 single user with call code listed in the directory
press to make the call.
(Option applicable for art. 3451, 3451A, 3451AS, 3451S, 3471)
Activating the lock-release relay by
entering the password code
√ In standby
1. Press .
2. Enter the password code.
ENTER PASSWORD:
******
OK
3. Press to confirm or to cancel and exit.
» A confirmation message will appear on screen when the proce-
dure is complete.
Activating the relay with the RFID key
√ In standby
„ Pass the key near the RFID sensor.
KEY ACCEPTED
» The green LEDs light up for a few seconds.
» "KEY ACCEPTED" appears on the display.
» The lock-release contact is opened.
KEY REJECTED
» The red LED flashes.
» "WRONG KEY" appears on the display.
to cancel and exit.
CANC
.
to exit.
002
CALL
CANC
3