Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
BEFORE THE FIRST USE
•
Take the appliance and accessories out the box. Remove the stickers,
protective foil or plastic from the device.
•
Place the device on a flat stable surface and ensure a minimum of
10 cm. free space around the device. This device is not suitable for
installation in a cabinet or for outside use.
•
Put the power cable into the socket. (Note: Make sure the voltage which
is indicated on the device matches the local voltage before connecting
the device. Voltage 220V-240V 50/60Hz)
MOUNTING
•
Place the feet on the pedestal and push / click them into place.
•
Insert the base tube into the pedestal and turn to lock it into place.
•
Remove height adjustment ring by unscrewing and sliding up.
•
Slide stand cover down onto the base and screw the height adjustment
ring back in place.
•
Loosen height adjustment ring to extend the extension rod and tighten
back into place.
•
Loosen rear fixing knob and attach extension rod.
•
Unscrew the rear locking ring from the motor shaft in anti-clockwise
direction.
•
Set the rear cage and fit it well on the two position holes and make sure
these holes are properly put through the holes on the rear cage.
•
Hold the rear cage and screw the rear locking ring into the motor front
cover in a clockwise direction.
•
Install the fan blade onto motor shaft and fit the fan blade lock cap.
•
Loosen the screw and nut on the bottom of the rear cage.
9
Publicité
Chapitres
Table des Matières
