EINHELL BT-CW 18 i Mode D'emploi page 9

Anleitung_BT_CW_18i_SPK1:_
Important!
When using equipment, a few safety precautions
must be observed to avoid injuries and damage.
Please read the complete operating manual with due
care. Keep this manual in a safe place, so that the
information is available at all times. If you give the
equipment to any other person, give them these
operating instructions as well.
We accept no liability for damage or accidents which
arise due to non-observance of these instructions
and the safety information.
1. Safety information
Please refer to the booklet included in delivery for the
safety instructions.
CAUTION!
Read all safety regulations and instructions.
Any errors made in following the safety regulations
and instructions may result in an electric shock, fire
and/or serious injury.
Keep all safety regulations and instructions in a
safe place for future use.
Additional safety instructions
Never allow the tool to run unloaded at full idle
speed for an extended period of time.
Wear the necessary protective clothing when
working with the screwdriver.
Wear hearing protection and protective gloves
When changing a tire on a vehicle, ensure that
you refer to the vehicle manufacturerʼs directions
for use.
After using the hammer screwdriver to tighten
screws / nuts on motor vehicles, the torque
specified by the vehicle manufacturer must be
checked with an appropriate measuring device
(torque wrench).
Important! Wheel nuts and bolts become tighter
during use of the vehicle. It is necessary therefore
to release the nuts/bolts with a matching wrench
(wheel spider) before undoing with the BT-CW 18.
If a certain torque is specified for other
screwdriving work, it is imperative that this is
checked with an appropriate measuring device
(torque wrench).
Only allow repairs and services to be carried out
by authorized professional repair shops.
11.03.2008 14:30 Uhr Seite 9
2. Layout (Fig. 1)
1. 1/2" External square drive mount
2. Carrying strap
3. Changeover switch
4. ON/OFF switch
5. Battery pack
6. Battery charger
7. Charging adapter
8. Pushlock button
3. Proper use
The hammer screwdriver is used for loosening and
tightening screws and nuts.
The machine is to be used only for its prescribed
purpose. Any other use is deemed to be a case of
misuse. The user / operator and not the
manufacturer will be liable for any damage or injuries
of any kind caused as a result of this.
Please note that our equipment has not been
designed for use in commercial, trade or industrial
applications. Our warranty will be voided if the
machine is used in commercial, trade or industrial
businesses or for equivalent purposes.
4. Technical data
Voltage supply
Idling speed:
Forward and reverse rotation
Maximum screw size
Battery charging voltage
Battery charging current
Mains voltage for charger 230 V ~ 50 Hz
Charging time: approx. 3-5 hours
Battery type:
Weight
GB
18 V d.c.
0-2000 rpm
yes
M 12
22 V d.c.
450 mA
NiCd
1.86 kg
9