Operation; Switching On/Off; General Functions - Renkforce SAP-702 Notice D'emploi

Operation


Please note that sound controls that are turned up very high already require very high performance of
the amplifier even at medium volume and can easily oversteer it. This results in distortions that may
damage the loudspeaker.
In case of high volumes and/or highly turned-up sound controls, check for distortions and turn down the
volume control or the sound controls immediately to prevent damage to the loudspeakers.

Switching On/Off

• Check again that all connections are correct.
• Turn the VOLUME control (1) to the left stop.
• Switch on the miniature amplifier with the mains switch (4) (set switch to ON position).
• The POWER (3) indicator is lit.
• To turn the amplifier off, turn the volume control VOLUME (1) back to the left stop and then turn the miniature
amplifier off with the mains switch (4) (put the switch to the OFF position).
If you do not observe this sequence, the loudspeaker of the miniature amplifier could be
damaged.

General Functions

• Turn the sound control (1) clockwise until you reach the desired volume.
• With the control BALANCE (5), set the volume balance between the left and the right loudspeaker channels. In
the central position, playback takes place at the same volume via both loudspeakers. Turning clockwise reduces
the volume of the left loudspeaker. Turning counter-clockwise reduces the volume of the right loudspeaker.
• With the control BASS (6), set the intensity of the bass playback.
Bass playback is amplified when turning the control clockwise. Bass playback is dampened when turning the
control counter-clockwise.
• With the control TREBLE (7), set the intensity of the treble playback.
Treble playback is amplified when turning the control clockwise. Treble playback is dampened when turning the
control counter-clockwise.
29