Operation; Switch On/Off; General Functions - Renkforce E-SA9M Notice D'emploi

Operation


Please note that sound controls that are turned up very high already require very high performance from
the amplifier even at medium value and can easily oversteer it. This results in distortions that may
damage the loudspeaker.
In case of high volumes and/or highly turned up sound controls, check for distortions and turn down the
volume control or the sound controls immediately to prevent damage to the loudspeakers.

Switch on/off

• Check again that all connections are correct.
• Turn the volume control VOLUME (16) to the „MIN" (left stop) setting.
• Switch on the amplifier with the POWER switch (2) (set switch to ON position).
• The power indicator (1) will light up.
• To turn the amplifier off, turn the volume control VOLUME (16) back to „MIN" (left stop) and then turn the amplifier
off with the mains switch POWER (2). Put the switch to the OFF position.
If you do not observe this order, the loudspeaker of the amplifier could be damaged.

General Functions

• Turn the sound control (16) clockwise until you achieve the desired volume.
• With the control BALANCE (12), set the volume balance between the left and the right loudspeaker channel. In
the central position, playback takes place at the same volume via both loudspeakers. Turning clockwise reduces
the volume of the left loudspeaker. Turning counter-clockwise reduces the volume of the right loudspeaker.
• With the control BASS (13), set the intensity of the bass playback.
Bass playback is amplified when turning the control clockwise. Bass playback is dampened when turning the
control counter-clockwise.
• With the control TREBLE (15), set the intensity of the treble playback.
Treble playback is amplified when turning the control clockwise. Treble playback is dampened when turning the
control counter-clockwise.
• The button SCREEN DISPLAY (24) on the remote control turns the display on or off.
34
Operating Instructions

English