EINHELL SB401 Mode D'emploi page 9

Anleitung SB 401-12 sprachig 07.11.2001 7:58 Uhr
8.4 Adjusting the height of the table
Slacken the tightening screw (6).
Move the table (7) to the required position by
lifting or lowering and turning to the left or right
as required.
Position the table (7) so there is still a big
enough gap between the workpiece and the tip
of the bit for you to start up the drill in idle.
Re-tighten the tightening screw (6).
If you want to drill a hole all the way through the
workpiece, make sure that the hole in the table (7) is
centrally positioned relative to the bit.
When working with large workpieces you can swing
the table (7) completely to the side in order to place
the workpiece directly on the base plate.
8.5 Speed table
The list below will help you select the right speed for
various materials.
The speeds quoted are guidelines alone.
Bit diameter Gray cast iron Steel Iron Aluminium
3 2550 1600 2230 9500
4 1900 1200 1680 7200
5 1530 955 1340 5700
6 1270 800 1100 4800
7 1090 680 960 4100
8 960 600 840 3600
9 850 530 740 3200
10 765 480 670 2860
11 700 435 610 2600
12 640 400 560 2400
13 590 370 515 2200
14 545 340 480 2000
16 480 300 420 1800
Seite 9
9. Maintenance
There is no need to lubricate the bearings of the SB
401. All the ball bearings are greased for life.
Lubricate all moving parts and threads regularly with
a drop of acid-free lubricating oil.
Use only a brush or rag to clean the machine.
Never use solvents to clean the painted parts.
Treat bare parts regularly with anti-corrosion agent.
10. Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
Bronze
8000
6000
4800
4000
3400
3000
2650
2400
2170
2000
1840
1700
1500
GB
9