Options - ZANKER KDT10012FK Notice D'utilisation

1)
Programme
3)
4)
5)
1) The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of dishes can
change the programme duration and the consumption values.
2) This programme has a high temperature rinsing phase for better hygiene results. During the rinsing phase, the temperature
stays at 70 °C for 10 to 14 minutes.
3) With this programme you can wash a load with fresh soil. It gives good washing results in a short time.
4) With this programme you have the most efficient use of water and energy consumption for crockery and cutlery with normal
soil. (This is the standard programme for test institutes).
5) Use this programme to quickly rinse the dishes. This prevents the remaining food to bond on the dishes and bad odours to
come out from the appliance.
Do not use detergent with this programme.
Information for test institutes
For all the necessary information for test performance. send an email to:
info.test@dishwasher-production.com
Write down the product number (PNC) that is on the rating plate.

Options

Acoustic signals
The acoustic signals operate in these conditions:
• When the programme is completed.
• A malfunction occurs to the appliance.
Factory setting: on.
You can deactivate the acoustic signals.
Deactivating the acoustic signals
1. Press the on/off button to activate the appliance.
2. Make sure that the appliance is in setting mode.
Refer to 'SETTING AND STARTING A PRO-
GRAMME'.
Degree of soil
Type of load
Normal soil
Crockery and cutlery
Fresh soil
Crockery and cutlery
Normal soil
Crockery and cutlery
All
Programme
phases
Prewash
Wash 65 °C
Rinses
Dry
Wash 60 °C
Rinse
Prewash
Wash 50 °C
Rinses
Dry
Prewash
3. Press and hold the programme button until the pro-
gramme indicator (A) flashes and the programme
indicator (B) comes on.
4. Press immediately the programme button.
• The programme indicator (A) comes on with a
fixed light.
• The programme indicator (B) starts to flash.
5. Wait until the programme indicator (A) goes off and
the end indicator comes on (the programme indica-
tor (B) continues to flash).
• The acoustic signals are on.
6. Press the programme button. The end indicator
goes off.
• The acoustic signals are off.
Duration Energy
(min) (kWh)
105 - 115 1.6 - 1.9
30 0.8
130 - 140 1.0 - 1.2
12 0.1
Water
(l)
18 - 20
9
14 - 16
5
17