Options; Before First Use - ZANKER KDT11002FK Notice D'utilisation

Options

Acoustic signals
The acoustic signals operate when the appliance has
a malfunction and it is not possible to deactivate them.
There is also an acoustic signal that operates when
the programme is completed. By default, this acoustic
signal is off, but it is possible to activate it.
How to activate the acoustic signal for the end of
programme
1. Press the on/off button to activate the appliance.
2. If necessary, do the Reset function.
3. Press and hold the programme button until the
programme indicator
the programme indicator
with fixed light.
4. Press immediately the programme button.
•
The programme indicator
with fixed light.
• The programme indicator
flash.

Before first use

1. Make sure that the set level of the water softener
agrees with the water hardness in your area. If
not, adjust the water softener. Contact your local
water authority to know the water hardness in your
area.
2. Fill the salt container.
Adjusting the water softener
German
degrees
(°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
starts to flash and
comes on
comes on
starts to
Water hardness
French mmol/l
degrees
(°fH)
84 - 90 8.4. - 9.0
76 - 83 7.6 - 8.3
65 - 75 6.5 - 7.5
51 - 64 5.1 - 6.4
40 - 50 4.0 - 5.0
5.
Wait until the programme indicator
off. The programme indicator
ues to flash.
6. Press the programme button. The end indicator
comes on. The acoustic signal for the end of pro-
gramme is activated.
7. Press the on/off button to deactivate the appliance
and to confirm the setting.
How to deactivate again the acoustic signal for the
end of programme
1. Refer to "How to activate the acoustic signal for
the end of programme" and follow the procedure
from step (1) to step (5). The end indicator is on.
2. Press the programme button. The end indicator
goes off. The acoustic signal for the end of pro-
gramme is deactivated.
3. Press the on/off button to deactivate the appliance
and to confirm the setting.
3. Fill the rinse aid dispenser.
4. Open the water tap.
5. Processing residues can stay in the appliance.
Start a programme to remove them. Do not use
detergent and do not load the baskets.
Clarke
degrees
58 - 63
53 - 57
46 - 52
36 - 45
28 - 35
goes
contin-
Water softener
adjustment
Level
10
9
8
7
6
17