Mitsubishi Electric PFAV-P250VM-E Manuel D'utilisation page 11

<Flashing Error Codes>
ERROR CODE
Error Code
Indoor Unit No.
If you have entered contact number to be called in the event of a problem, the screen
displays this number. (You can set this up under Function Selection of remote controller.
For information, refer to section 3.4.)
If the ON lamp and error code are both flashing: This means that the air
conditioner is out of order and operation has been stopped (and cannot
resume). Take note of the indicated unit number and error code, then switch
off the power to the air conditioner and call your dealer or servicer.
°C
When the Check button is pressed:
CALL:XXXX
XXX:XXX
If only the error code is flashing (while the ON lamp remains lit): Operation is
continuing, but there may be a problem with the system. In this case, you
should note down the error code and then call your dealer or servicer for
advice.
* If you have entered contact number to be called in the event of a problem,
push the Check button to display it on the screen. (You can set this up under
Function Selection of remote controller. For information, refer to section 3.4.)
ON lamp
ON/OFF
(Flashing)
ERROR CODE
°C
ON/OFF
Error Code
ON/OFF
11