Hama HOME S7 Mode D'emploi page 10

g
S e
Insert the paper into the centre of the feed shaft (4). The cutting
rollers are switched on automatically.
Let go of the paper. The device switches back to standby mode
after shredding is completed.
e e e
Slide the operating switch (2) to the "Rev" position. The rollers of
the paper cutting system rotate in the opposite direction.
Pull the paper up and out of the feed shaft (4).
To return the device to standby mode, set the operating switch (2)
back to ON/AUTO.
m
To switch the device off, slide the operating switch (2) to the "Off"
position.
Lift the cutting attachment off of the waste bin (1).
Empty the bin.
Place the cutting attachment back onto the waste bin (1).
S
Slide the operating switch (2) to the "Off" position.
e
Empty the bin frequently in order to prevent damage to the
device.
mo e
These modes serve to remove any blockages in the cutter
system.
e
o e e e
Home S7