Tristar KZ-1228 Mode D'emploi page 7

BRewINg coFFee wITH FReSHly gRouND BeaNS
1. Open the water reservoir lid.
2. Pour the desired amount of water into the water reservoir. On the
water level indication, you can see how many cups of water you have
already poured into the water reservoir. Always fill the water reservoir
with at least two up to a maximum of 12 cups of water. Use the glass jar
to fill the water reservoir with water.
3. Then close the water reservoir lid.
4. Open the filter compartment by pressing the unlocking button on the
side of the device.
5. Place the filter compartment insert, the permanent filter and the filter
compartment cover into the filter compartment. Make sure that all
parts are placed in correctly as otherwise the coffee machine will not
start the brewing procedure.
6. Close the filter compartment.
7. NOTE, before you start making coffee check if the permanent filter is empty.
8. Fill coffee beans into the grinding mechanism of the coffee machine.
Then place the lid of the grinding mechanism back on.
9. Place the glass pot on the hotplate.
10. Use the 2–12 cups button to set the number of cups you would like to brew.
11. You can press the coffee strength button to set the coffee strength.
You have a choice of three levels which are shown to you on the
display as follows:
The level mild represents a mild coffee flavour, the level medium
represents a medium coffee flavour and the level strong represents an
aromatically strong coffee flavour.
12. Press the on/off button to switch on the device. The on/off button
lights up.
13. As soon as you have pressed the on/off button, the grinding
procedure begins. After the grinding procedure, the brewing
procedure starts immediately. The grinding process can be noisy, this
sound is normal for such devices.
14. After the brewing procedure, you can take the glass pot from the
hotplate and serve the coffee.
15. After the brewing procedure, the hotplate remains on for another two
hours and then switches off automatically.
16. If you would like to turn off the coffee machine before the two hours
are up, press the on/off button.
17. Clean the device after use as described in the "Care and Descaling" chapter.
Tip: The coffee machine has a non-drip valve. You can also take the
glass pot from the hotplate during the brewing procedure and pour
yourself a cup of coffee. But be careful: You should place the glass pot
back on the hotplate within 20 seconds to prevent the coffee filter from
overflowing with water!
Brewing coffee with Powder coffee
1. Open the water reservoir lid.
2. Pour the desired amount of water into the water reservoir. On the
water level indication, you can see how many cups of water you have
already filled in the water reservoir. Always fill the water reservoir with
at least two up to a maximum of 12 cups of water. Use the glass jar to
fill the water reservoir with water.
3. Then close the water reservoir lid.
4. Open the filter compartment by pressing the unlocking button on the
side of the device.
5. Place the filter compartment insert and the permanent filter into the
filter compartment. Make sure that all parts are placed in correctly as
otherwise the coffee machine will not start the brewing procedure.
Coffee maker
eN
7