Publicité
Les langues disponibles
Les langues disponibles
Instruction manual
BeFoRe INITIal uSe
Before you can use the device, you must:
• unpack the items supplied,
• clean the device.
uNPackINg
PleaSe NoTe!
• Keep children and animals away from the packaging material. There is
a danger of suffocation!
• Unpack all parts and check the scope of supply for completeness;
also check for transport damage. If you find any damage to the
components, do not use them (!), but contact our customer service
department.
cleaNINg
PleaSe NoTe!
Do not use corrosive or abrasive cleaning agents to clean the device. These
could damage the surface.
1. Press the button for unlocking the filter compartment on the side of
the device.
2. Remove the filter compartment insert together with the permanent filter.
3. Now clean the filter compartment insert and permanent filter with hot
water and a little detergent if necessary.
4. Then dry all parts thoroughly and place them in the coffee machine
again.
6
5. We recommend that, prior to first use, you operate the device three
times with just water (no coffee) to flush through all the lines etc.
Please ensure that you have switched on the grind off function if you
want to flush the device with water. Before first using the device, also
observe the notices in the "Use" chapter.
uSe
PleaSe NoTe!
• The device has no automatic water-dosing function. Therefore, fill only
as much water as you need into the water reservoir.
• Make sure that the filter cover is placed on correctly as otherwise the
device will not start the brewing procedure!
• Make sure that the maximum marking of the water level indication
is not exceeded when you pour water into the water reservoir of the
device. Take care when pouring in water: To make it impossible to
overfill the water reservoir, there is an opening on the back of the
water reservoir from which excess water can escape.
commissioning and making Basic Settings
1. Place the device on a level, firm and heat-resistant surface.
2. Connect the device to a mains socket that has been properly installed.
3. The preset time "12:00" will appear on the display.
4. Set the time using the Hour and Minute buttons.
Publicité
