Télécharger Imprimer la page

Zibro P 122 Manuel D'utilisation page 57

Masquer les pouces Voir aussi pour P 122:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 40
DEHUMIDIFYING
When the unit is primarily used as a dehumidifier, then please follow these
i n s t ructions: Do n o t connect the air exhaust hose and let the warm air go
back into the room. Connect a drainage hose onto the permanent drain
connector on the back of the unit (refer to Chapter G). You must connect a
drain tube to the water outlet
When the unit is in the dehumidifying mode, the fan speed
adjusted. The fanspeed will be automatically set on 'Medium setting'. The
buttons
and
can also not be adjusted.
AIR CIRCULATION
In this mode the unit only circulates air; the unit will not cool or dehumidify.
The air entering the unit is not cooled or dehumidified, but is filtered.
When the unit is in this mode, the following functions apply:
The fan speed can be adjusted by pressing the
Maximum setting.
Medium setting.
Lowest setting.
When the unit is switched off the most recent setting will be stored in
memory.
The timer function allows you to switch the unit on or off at a certain time.
TO SWITCH ON THE UNIT AT A CERTAIN TIME
Ensure that the unit is set in the required operating mode
Switch off the unit by pressing the
properly inserted into the wall outlet.
Press the
-button. The light "Timer set" will flash.
Use the
and
When the set time has expired the unit will switch on.
TO SWITCH OFF THE UNIT AT A CERTAIN TIME
When the unit is operating in the re q u i red mode press the
The light "Timer set" will flash.
Use the
and
When the set time has expired the unit will switch off.
N O T E !
The compressor has been set so that it starts functioning three minutes
after the (re)start of the air conditioner.
The cooling will switch off when the room temperature is lower than
the set one. Air circulation will however continue to work on the set
level. When the room temperature rises above the selected value, the
cooling will work again.
(refer to Chapter G).
-button. Ensure that the plug is
buttons to set a time between 1 and 12 hours.
buttons to set a time between 1 and 12 hours.
cannot be
-button
,
of
.
- b u t t o n .
4
57

Publicité

loading

Ce manuel est également adapté pour:

P 125