Cyclic Inputs/Outputs - Georges Renault DEVICE NET Manuel Opérateur

Example of network:
PLC (Master)
Station address = 1

3 - Cyclic Inputs/Outputs

A tightening controller may consist of 2 stations in the event of an asynchronous operation.
Via the cyclic inputs-outputs, you can therefore control the 2 stations of a tightening controller.
The standard cyclic input-output area of a tightening controller consists of the following:
- 6 input words
- 6 output words
Reminder: the master must be configured with the previous information to access the slave.
Outputs: Write-only data for the PLC (Standard I/O)
Index
1 Network inputs (channel 1)
2 Network inputs (channel 2)
3 24 volt input mask (channel 1)
4 24 volt input mask (channel 2)
5 Cycle no. selection (Station 1)
6 Cycle no. selection (Station 2)
Inputs: Write-only data for the PLC (Standard I/O)
Index
1 24 volt outputs (channel 1)
2 24 volt outputs (channel 2)
3 24 volt inputs (channel 1)
4 24 volt inputs (channel 2)
5 Cycle no. acknowledge (Station 1)
6 Cycle no. acknowledge (Station 2)
Note 1
"Cycle number selection"
This data is taken into account only when the "Source of cycle number" option is set to "PLC" in the tightening controller.
Operator's Manual
DEVICE NET
TWINCVI (DN slave)
Station address = 3
TWINCVI (DN slave)
Station address = 5
Description
Description
Type Size
Value
bytes
Word 2
Word 2
Word 2
Word 2
Word 2 Note 1
Word 2 Note 1
Type Size
Value
bytes
Word 2
Word 2
Word 2
Word 2
Word 2
Word 2
6159932680-01
English
7/28