Westfalia 317083600001 Mode D'emploi page 2

SIARR
26 - 27
PREPARATION
* Remove the bumper
* Remove: * from each site 3 screws and 1 clip at the end of the quarter panel -
* under the bumper 2 clips - * 2 screws on top at the level of the boot
* Remove the absorber and cut the bumper as shown in detail 1.
ASSEMBLY
* On the outside of the rails, locate and remove the two covers
blocking the attachment points W and X of the arms.
* Insert the arms inside the rails at points W and X, then attach,
without tightening, with the help of screw sets W and X.
* Raise the hitch unit to points V and W, then attach with
screw units V and W.
FINISHING
* Tighten the assembly at the couples indicated below
in the following order: X - W - Y.
* Attach the hitch and the jack support
to points Y with screw set Y.
FASTENING KIT
2 HM10x30 screws
V
2 DEC10 washers
2 HM10x35 screws
W
2 DEC10 washers
2 10,5x35 plain washers
2 HM10x30 screws
X
2 DEC10 washers
2 10,5x35 plain washers
M16 AC8.8 19,5daNm M12
M16 AC10.9 27,5daNm M10
M12 AC8.8 8,1daNm M10
ASSEMBLY INSTRUCTIONS
2 HM12x60 screws
2 DEC12 washers
Y
2 HM12 nuts
1 12,5x27 plain washer
2 HM16x40 screws
Z
2 DEC16 washers
2 HM16 nuts
TORQUES :
AC10.9 11,4daNm M8 AC8.8
AC8.8 4,7daNm M8 AC10.9
AC10.9 6,7daNm
Type Type
SI052 Approval No.
Tow bar for
SKODA e24*94/20*00*0081
Roomster (Std)
NB : Electrical diagram inside our universal or custom wiring kits.
PLEASE NOTE : (to familiarise yourself with the operating charasteristics refer to the log)
2,3daNm If this tow bar is fitted in accordance with our recommendations it will give a complete-
3,3daNm ly satisfaction. We cannot accept any responsability in the event of changes to or
improper use of this item.
FICHIER : BUREAU\NOTICEDEMONTAGE\SIARR\NDM26\NDM2627-A - FOLIO NDMANG
!
Affix the sticker in the position
Max. Total Max. Total
Authori. Weight Towable Weight
1 600 kg 1 200 kg
317083600001
Max. Verti- Value
cal load D
60 kg 6,73 kN