Publicité
Les langues disponibles
Les langues disponibles
3. Assembly and Installation
3.2.4. Positioning of the assembly components
After connecting the inlet and outlet lines, check whether the assembly components are
in a vertical position. If they are not, position them according to the following figure. Push
the inlet pipe towards the wall of the tank until the spacer touches the wall. The outlet
pipe must be pushed as far in the direction of the wall, until the complete pipe cross
section is still visible from above on the installed structure.
Positioning the pipe axis
Position the inlet and outlet constructions vertically
KLsepa.pop
24
Publicité
