Festool LEX 3 77/2,5 Notice D'utilisation D'origine page 16

7.4 Dust extraction
WARNING
Dust hazard

Always work with a dust extractor.

Always observe country-specific regulations.
 For use of a Festool mobile dust extractor with
flow sensor: Adjust hose diameter of mobile
dust extractor to Ø 27 mm.
To guarantee optimal dust extraction, we recom-
mend using Festool extractors with automatic
switch-on/switch-off device for compressed air
machines.
In order to prevent damage to the pneumatic
motor, dust extraction must not be carried out on
the pneumatic tool when it is at standstill.
8 Working with the machine
Please observe all mentioned safety infor-
mations and the following rules when work-
ing:
– Always secure the workpiece in such a manner
that it cannot move while being processed.
For work that generates dust, wear a dust
mask.
9 Service and maintenance
WARNING
Risk of injury

The machine should always be disconnected
from the compresses air supply before any work
is carried out on the machine.

All maintenance and repair work which requires
the motor casing to be opened may only be car-
ried out by an authorised service centre.
Customer service and repair only
through manufacturer or service
workshops: Please find the nearest
address at:
EKAT Use only original Festool spare parts!
4
Order No. at:
5
3
2
1
9.1 Vanes
We recommend that the vanes on the motor be re-
placed after approx. 2000 operating hours.
9.2 Replacing the silencer
In order to maintain the power and performance of
the compressed air tool, replace the silencer on the
IAS hose systems at regular intervals.
9.3 Sanding pad brake
The rubber sleeve [5-1] brushes off the sanding
pad and prevents uncontrolled turning of the sand-
ing pad. This must be replaced if the braking effect
decreases.
9.4 Cleaning the extraction channels
We recommend cleaning the extraction channels in
the machine [5-2] roughly once a week (particularly if
sanding synthetic resin, in the case of wet sanding and
if sanding plaster) using a small flat brush or a cloth.
10 Accessories
The order numbers of the accessories and tools can
be found in the Festool catalogue or on the Internet
under " ".
11 Environment
Do not dispose of the device together with domes-
tic waste! Dispose of machines, accessories and
packaging at an environmentally responsible recy-
cling centre. Observe the valid national regulations.
Information on REACh:
12 EU Declaration of Conformity
Compressed air eccentric sander
LEX 3 77/2.5
LEX 3 125/3
LEX 3 125/5
LEX 3 150/3
LEX 3 150/5
Year of CE mark: 2012
LEX 3 150/7
Year of CE mark: 2013
We declare under sole responsibility that this product
complies with all the relevant requirements in the follow-
ing Directives, standards and normative documents:
DIN EN ISO 11148-8 i.a.w. the provisions of 2006/
42/EC Directive.
Dr. Johannes Steimel
Head of Research, Development and Technical
Documentation
LEX 3
GB
Serial no.
496675
496890
496891
496886
496887
496888
17