Publicité
Les langues disponibles
Les langues disponibles
4.
Take the filter out of the dust box while pulling the
outer bottom edge of the cardboard opening free from
the lower hooking tab.
2
1
Fig.17
► 1. Filter 2. Cardboard opening 3. Upper hooking tab
4. Lower hooking tab 5. Dust box
5.
Replace a filter by engaging the bottom edge of
the cardboard opening in the lower hooking tab and
push the top edge inwards until it clips into the upper
hooking tab .
2
1
Fig.18
► 1. Filter 2. Cardboard opening 3. Upper hooking tab
4. Lower hooking tab 5. Dust box
6.
holding the locking latches on both sides of the dust box.
3
1
4
Fig.19
► 1. Dust nozzle 2. Dust box 3. Locking latch
5
Removing and installing front grip
grip to check if it is securely attached together.
NOTICE:
slot end and keep it positioned where it is while rotating
the front grip. Failure to do so may cause damage to the tool.
By removing the detachable front grip, sanding operation in tight,
confined and hard-to-reach areas can be performed effectively.
Uninstallation
Push and hold the front grip firmly towards the motor
housing and rotate it 90 degrees to either the left or
right. Then pull it apart from the tool.
Installation
Insert the end of the front grip into the slot on the motor hous-
ing, aligning the outlines of the grip end with those of the slot.
3
Push and hold the front grip firmly towards the housing and
rotate it 90 degrees with its gripping surface facing upwards.
4
5
1
Fig.20
► 1. Front grip 2. Slot 3. Motor housing 4. Gripping surface
11 ENGLISH
Snap the dust nozzle into place while pressing and
2
3
CAUTION:
After reassembly, pull the front
Make sure to push the front grip fully into the
4
3
2
3
Publicité
