Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
2. SCOPE OF DELIVERY
1 x
Loading ramp, folding with carry handle
1 x
Ramp base with safety chain
1 x
Wheel stop
4 x
Screw M10 x 20 with lock nut (pre-mounted)
3. SPECIFICATIONS
Maximum payload: 800 kg when folded
250 kg
Size (L x W x H):
Approx. 200 x 26 x 5 cm
when folded
approx. 90 cm with loading angle
4. SAFETY INSTRUCTIONS
• Keep children away and do not allow children to operate this device!
• Only use this product as intended!
• Do not manipulate or dismantle the device!
• For your own safety, only use accessories and spare parts that are stated in these Instructions or are recommended by the manufacturer!
• The folding loading ramp is not suitable for increasing the payload of an existing ramp
Use as loading ramp
•
Only use as a loading ramp for unloading and loading on hard and even surfaces.
•
Do not exceed the maximum payload of 250 kg. Observe the maximum payload of the tailboard and bed (consult the manual of your vehicle).
•
Keep hands, feet, tools or other devices away from the ramps. Do not lie under the ramp.
•
Do not use a damaged or not fully functional ramp. Have a damaged ramp repaired by the manufacturer or an authorised workshop.
•
Do not exceed the bed height of 102 cm.
•
Always secure the ramp base with the safety chain to prevent slippage.
•
Keep the ramp clean of water, mud and oil.
•
The ramp is not suitable for wheels or chains made of steel.
•
Trailers may only be loaded/unloaded when attached to a vehicle. Let down the supports.
•
Secure the vehicle to be loaded to prevent it from rolling away (put into gear, set automatics to P, activate the parking break, put wedges under the wheels).
•
Always drive straight onto the ramp and keep central. When loading double-track vehicles, pay attention to the track width and align the ramps so that they
are parallel.
•
When driving onto the ramp, avoid sudden braking or starts.
Use as installation ramp
•
Only use the installation ramp on hard and even, non-slip surfaces.
•
Do not exceed the maximum payload of 800 kg.
•
Do not use a damaged or not fully functional ramp. Have a damaged ramp repaired by the manufacturer or an authorised workshop.
•
Keep the ramp clean of water, mud and oil.
•
Secure the vehicle to prevent it from rolling away (put into gear, set automatics to P, activate the parking break, put wedges under the wheels).
•
Do not use any other lifting gear in conjunction with the ramp.
5. OPERATING INSTRUCTIONS
INSTALLATION
Figure 1
Place the folded loading ramp on the side, and release the carry handle. Unfold the upper section. Secure the ramp base using 2 screws M8 x 40, 2 screws M8 x 20 and
washers and nuts to the upper section of the ramp, see Figure 1. The side struts of the loading must face downwards. See Figures 3 and 4.
Loading height:
Height of the installation ramp: Approx. 18 cm
Maximum tyre width:
Weight:
Material:
Figure 3
2 x
Screw for M8 x 40 with nut and washer
2 x
Screw for M8 x 20 with nut and washer
2 x
Screw for M8 x 15 with washer
1 x
Screw for M6 x 16 with nut and washer
Approx. 102 cm
225 mm
Approx. 14 kg
Steel
Figure 2
Figure 4
5
Publicité
Table des Matières
