Makita LS0714 Manuel D'instructions page 22

3
► 1. Triangular rule 2. Grip 3. Guide fence
Make sure that the pointer points to 0° on the miter
scale. If the pointer does not point to 0°, loosen the
screw which secures the pointer and adjust the pointer
so that it will point to 0°.
1
2
► 1. Screw 2. Miter scale 3. Pointer
Bevel angle
0° bevel angle
Push the carriage toward the guide fence and tighten
two clamp screws to secure the carriage. Lower the
handle fully and lock it in the lowered position by push-
ing in the stopper pin. Loosen the lever at the rear of
the tool.
Turn the 0° bevel angle adjusting bolt (lower bolt) on the
right side of the arm two or three revolutions counter-
clockwise to tilt the blade to the right.
2
► 1. Lever 2. Arm holder 3. 0° degree bevel angle
adjusting bolt 4. Arm 5. Release button
Carefully square the side of the blade with the top
surface of the turn base using the triangular rule, try-
square, etc. by turning the 0° bevel angle adjusting bolt
clockwise. Then tighten the lever securely.
1
2
► 1. Triangular rule 2. Saw blade 3. Top surface of
Make sure that the pointer on the arm point to 0° on the bevel scale
on the arm holder. If it does not point to 0°, loosen the screw which
secures the pointer and adjust the pointer so that it will point to 0°.
3
► 1. Bevel scale 2. Pointer 3. Screw
45° bevel angle
1
► 1. Left 45° bevel angle adjusting bolt
5
Adjust the 45° bevel angle only after performing 0° bevel
4
angle adjustment. To adjust left 45° bevel angle, loosen the
lever and tilt the blade to the left fully. Make sure that the
3
pointer on the arm points to 45° on the bevel scale on the arm
holder. If the pointer does not point to 45°, turn the 45° bevel
angle adjusting bolt (upper bolt) on the right side of the arm
until the pointer points to 45°.
22 ENGLISH
1
turn table
1
2
2
3
3
1