Technical Data And Accessories; Troubleshooting - LTR BSG V4 Notice D'utilisation

6. Technical data and accessories

Pressure gauge measuring range:
Power supply:
Filling hose:
Dimensions:
Weight:
Operating, ambient
temperature range:
Air humidity:
Fuse values:
IP protection class:
Supply connection (for cart)
Accessories see page 31:
FW
FW 11ODL
FW 230DL
NOTE:
• For information on evaluating the brake fluid, see the section on brake systems in the
current Leitenberger catalogue.
• EBT 01 Electric brake fluid tester (100124 for DOT 4).
• EBT 03 Electric brake fluid tester (100128 for DOT 3, DOT 4, DOT 4 Plus and DOT 5.1).
• EBT 06 Electric brake fluid tester (100134 for DOT 3, DOT 4 and DOT 5.1).
• BC 04 Refractometer (100601 measuring of refractive indices for DOT 4 and DOT 4 Plus).

7. Troubleshooting

Problem
Pump suction failure
Pump fails to run on automatically
No power supply at unit
No voltage on the on-board socket
0 to 4 bar
depending on unit model: 12 VDC, 115 VAC , 230 VAC
with quick coupling: 3 m
300 / 350 / 400 mm (W/D/H
5 kg
0...45 °C
40 - 60%
1A time-lag fuse
IP20
available voltage = supply voltage of the device current drain max. 1A
100513_1 Cart (can be used for all BSG models)
100513_2 Cart, 115 VAC with extraction unit, for units with 115 V power supply
100513_3 Cart, 230 VAC with extraction unit, for units with 230 V power supply
Cause
Original brake fluid container empty
Pressure regulator set to „MINUS"
Suction hose kinked
Filter suction hose clogged
Original brake fluid container empty
Fuse defective
Fuse defective or ignition not
activated
Remedy
Replace original brake fluid container
Set correct operating pressure
Remove kink, replace defective
hose
Clean or replace filter
Replace original brake fluid
container with new one
Replace fuse
If necessary replace the fuse, insert
the ignition, check the socket.
- 13 -