Installing Debris Shield - Maruyama B23C Manuel Du Propriétaire

1. Install the plastic tube (packed with the driveshaft
assembly) around the throttle cable and stop
switch wires.
2. Plug the stop switch wires into the matching connect-
ors from the engine. Note that wire polarity is not
important.
Connecting Throttle Cable
1. Loosen the knob and remove the air filter cover,
insert the throttle cable through the cable adjuster
sleeve on the carburetor bracket. Make sure theend
of the cable housing is seated positively in the
sleeve.
2. Position the slotted fitting on the carburetor so the
recessed hole for the cable lug is away from the
cable adjuster sleeve.
3. Rotate the carburetor throttle cam clockwise and
slip the throttle cable through the slot in the slotted
fitting, making sure the cable lug drops into
the recessed hole.
4. Operate the throttle trigger a few times to make
sure that it works correctly.
5. Adjust the cable adjuster sleeve so the stop on the
carburetor throttle cam just contacts the throttle
stop when the throttle trigger is fully depressed.
6. When the throttle cable is adjusted correctly, tighten
the locknut.
7. Reinstall the air filter cover and tighten the knob.

Installing Debris Shield

1. Fasten the string cutoff blade to the debris shield
with two M5x15 screws, hex nuts and lock washers
as shown.
2. Push the debris shield onto the bearing case. Install the
M6x40 screw and nut.
Tighten ONLY AS NEEDED
― US-10 ―