Operation; Operating Position - Maruyama B23C Manuel Du Propriétaire

• Do not pull the Starter rope all the way out.
WARNING
• Do not disassemble the Starter.
Please ask for an authorized MARUYAMA
service dealer.
After the engine starts, squeeze and release the
throttle trigger to return it to the idle position, then
move the choke lever to the open (
If the engine stops running before you move the
choke lever to the open (
Go ahead and open the choke, pull the starter grip with
the throttle tigger positioned at Fast-idle position.
Hot Restart
To start an engine that is already warmed up (hot
restart), or if the ambient temperature exceeds 68°F
(20°C):
1. Pump the primer bulb at the bottom of the car-
buretor until fuel can be seen flowing through the
fuel return line to the fuel tank.
2. Move the choke lever to the open (
and move the stop switch to the "ON" position.
3. Leave the throttle trigger in the idle position and
pull the starter grip.
4. If the engine fails to start after three to four pulls,
follow the instruction in the Cold Starting
Procedure section (this page).
CAUTION
) position.
) position:
) position
If the engine fails to start after you follow the
above procedures, contact an authorized
MARUYAMA dealer.
To Stop The Engine:
1. Release the throttle trigger.
2. Slide the stop switch to the "STOP" position.

Operation

POTENTIAL HAZARD
・Foreign objects can be thrown by String Trimmer.
WHAT CAN HAPPEN
・Contact with thrown objects can cause personal
injury.
HOW TO AVOID THE HAZARD
・Never operate the String Trimmer without the
guard.
• Read the Safety instructions on page US-6
concerning proper use of the String Trimmer.

Operating Position

Before using the Trimmer, check the following:
1. Make sure the Holding Tool (3mm hexagonal wrench)
has beenremoved from the gearcase and boss adapter
beforeyou start the engine.
― US - 14 ―
WARNING
CAUTION