Würth AWS 18-125 P COMPACT Mode D'emploi page 28

Under abusive conditions, liquid may be
ejected from the battery; avoid contact.
water. If liquid contacts eyes, additionally
seek medical help. Liquid ejected from the
battery may cause irritation or burns.
Do not use a battery pack or tool that is
batteries may exhibit unpredictable behaviour
Do not expose a battery pack or tool to
explosion.
Follow all charging instructions and
do not charge the battery pack or tool
in the instructions. Charging improperly or
Service
Have your power tool serviced by
identical replacement parts. This will ensure
that the safety of the power tool is maintained.
Never service damaged battery packs.
Service of battery packs should only be performed
by the manufacturer or authorized service
providers.
Angle Grinder Safety Warnings
Safety warnings common for grinding
This power tool is intended to function as
warnings, instructions, illustrations and
tool. Failure to follow all instructions listed below
injury.
Operations such
Exposure
as sanding, wire
brushing or polishing
recommended to be performed with this
power tool. Operations for which the power tool
was not designed may create a hazard and cause
personal injury.
Do not use accessories which are not
by the tool manufacturer. Just because the
accessory can be attached to your power tool, it
does not assure safe operation.
The rated speed of the accessory must
be at least equal to the maximum speed
marked on the power tool. Accessories
running faster than their rated speed can break
The outside diameter and the thickness
of your accessory must be within the
capacity rating of your power tool.
Incorrectly sized accessories cannot be adequately
guarded or controlled.
Threaded mounting of accessories must
match the grinder spindle thread. For
that to do not match the mounting hardware of
the power tool will run out of balance, vibrate
excessively and may cause loss of control.
Do not use a damaged accessory. Before
each use inspect the accessory such as
abrasive wheels for chips and cracks,
backing pad for cracks, tear or excess
wear, wire brush for loose or cracked
wires. If power tool or accessory is
dropped, inspect for damage or install an
undamaged accessory. After inspecting
and installing an accessory, position
yourself and bystanders away from the
plane of the rotating accessory and run
the power tool at maximum no-load
speed for one minute. Damaged accessories
will normally break apart during this test time.
Wear personal protective equipment.
Depending on application, use face
are not
Accessories
28